Tutorial.ChatClient History

Hide minor edits - Show changes to markup

October 27, 2015, at 09:38 AM by Arturo -
Changed line 42 from:
to:
October 27, 2015, at 09:38 AM by Arturo -
Changed line 42 from:
to:
October 27, 2015, at 09:37 AM by Arturo -
Changed line 42 from:
to:
Changed lines 60-61 from:


Last revision 2015/08/13 by SM

to:

\\

August 13, 2015, at 12:39 PM by Simone Maiocchi -
Changed line 42 from:
to:
Changed lines 60-61 from:

‘‘Last revision 2015/08/13 by SM’’

to:


Last revision 2015/08/13 by SM

August 13, 2015, at 12:37 PM by Simone Maiocchi -
Changed lines 1-11 from:
to:
Added lines 5-17:
Changed lines 21-28 from:

The Ethernet shield allows you to connect a WizNet Ethernet controller to the Arduino via the SPI bus. It uses pins 10, 11, 12, and 13 for the SPI connection to the WizNet. Later models of the Ethernet shield also have an SD Card on board. Digital pin 4 is used to control the slave select pin on the SD card.

The shield should be connected to a network with an ethernet cable. You will need to change the network settings in the program to correspond to your network.

to:

The Ethernet shield allows you to connect a WizNet Ethernet controller to the Arduino or Genuino boards via the SPI bus. It uses pins 10, 11, 12, and 13 for the SPI connection to the WizNet. Later models of the Ethernet shield also have an SD Card on board. Digital pin 4 is used to control the slave select pin on the SD card.

The shield should be connected to a network with an ethernet cable. You will need to change the network settings in the program to correspond to your network.

Changed lines 29-30 from:

In the above image, your Arduino would be stacked below the Ethernet shield.

to:

In the above image, the Arduino or Genuino board would be stacked below the Ethernet shield.

Changed lines 40-41 from:
to:
Changed lines 46-47 from:
to:

See also

‘‘Last revision 2015/08/13 by SM’’

January 16, 2012, at 03:17 PM by David Cuartielles -
Changed line 39 from:
to:
September 17, 2010, at 04:39 PM by Tom Igoe -
September 17, 2010, at 04:39 PM by Tom Igoe -
September 17, 2010, at 04:39 PM by Tom Igoe -
Added lines 1-44:

Share