display() and noDisplay() methods

The Liquid Crystal Library allows you to control LCD displays that are compatible with the Hitachi HD44780 driver. There are many of them out there, and you can usually tell them by the 16-pin interface.

This example sketch shows how to use the display() and noDisplay() methods to turn on and off the display. The text to be displayed will still be preserved when you use noDisplay() so it's a quick way to blank the display without losing everything on it.

Hardware Required

  • Arduino Board

  • LCD Screen (compatible with Hitachi HD44780 driver)

  • pin headers to solder to the LCD display pins

  • 10k ohm potentiometer

  • 220 ohm resistor

  • hook-up wires

  • breadboard

Circuit

Before wiring the LCD screen to your Arduino board we suggest to solder a pin header strip to the 14 (or 16) pin count connector of the LCD screen, as you can see in the image above. To wire your LCD screen to your board, connect the following pins:

  • LCD RS pin to digital pin 12

  • LCD Enable pin to digital pin 11

  • LCD D4 pin to digital pin 5

  • LCD D5 pin to digital pin 4

  • LCD D6 pin to digital pin 3

  • LCD D7 pin to digital pin 2

Additionally, wire a 10k pot to +5V and GND, with it's wiper (output) to LCD screens VO pin (pin3). A 220 ohm resistor is used to power the backlight of the display, usually on pin 15 and 16 of the LCD connector

click the images to enlarge

LCD Base bb Fritz

image developed using Fritzing. For more circuit examples, see the Fritzing project page

Schematic

click the images to enlarge

LCD Base bb Schem

image developed using Fritzing. For more circuit examples, see the Fritzing project page

Code

See Also

Last revision 2023/10/16 by JH