All the standard components have been packed together as tightly as possible on this board, leaving room for a prototyping area of solder points (like perf board). Good if you only need a couple extra parts for a prototype. The trade-off is that this board doesn't have a serial or USB port. You need to program it with an external programmer.
Eagle files (schematic and board layout), single-side variant of this board (only 4 jumper wires, no connector moved, uses Eagle SCH file from original)
Digikey parts from Tom Igoe
Parts | Qty | Value | Device | Farnell | RS | Distrelec | Digikey |
S1 | 1 | Reset pusbutton | 535916 | SW400-ND | |||
IC2 | 1 | 78xxL | 7805 TO220 | 701853 | LM7805CT-ND | ||
LED1 | 1 | Green LED | 656719 | 160-1144-ND | |||
X2 | 1 | 2.1mm power jack | 224959 | CP-102AH-ND | |||
Q1 | 1 | 16 MHz Quartz | 641029 | 300-6034-ND | |||
D1 | 1 | 1N4004 | 1N4004 or equivalent | 251707 | 1N4004GICT-ND | ||
R5 | 1 | 10k | 1/4 W resistor | 509280 | 10KQBK-ND | ||
C2, C3 | 2 | 22p | Polyester Capacitor | 896410 | 1330PH-ND | ||
C1, C5 | 2 | 100n | Polyester Capacitor | 146079 | P4201-ND | ||
C6, C7 | 2 | 100u | Electrolitic Capacitor | 920629 | P10269-ND | ||
R2 | 1 | 220 | 1/4 W resistor | 509097 | 220QBK-ND | ||
X3 | 1 | 28pin IC socket | ED3128-ND | ||||
IC1 | 1 | ATMEGA8 | Atmega8 28pin DIP microcontroller | 3917927 | ATMEGA8-16PI-ND | ||
ICSP | 1 | ICSP | 2x3 pins header | 3291947 | A26509-20-ND |
Note: some part numbers (e.g. C4) are unused because this schematic was made by deleting pieces of the Arduino serial schematic.